Hi, everyone, my name's Matt. I'm an active member on S/W, but I'd like to see some stuff other than E36s.
I drive a 2006 Focus ST. My car is a pretty basic example, with not much done to it. Here are some pics of it on the old wheels I just sold. 17x7.5 et42 wrapped in 215/45. No spacers.
Next to a totally sweet Lancer I found at WalMart
I lowered it more for winter (comparison pics with my sister's stock '07 SE):
Here are some better pics from when the car was a bit taller and I had just done the coilovers. Most of the stickers have obviously been removed since then.
So jealous of the one on the right.
Mod List:
Body:
-Lamin-X Eyelids
-Lightly tinted taillights
-Rolled/pulled fenders
Handling/Traction:
-Keegan Komponents front endlinks
-Keegan Komponents toe arms
-H&R coilovers
-Energy Suspension rear endlinks
-Bridgestone Potenza RE-11 (215/45/17)
-Elbrus I05 wheels (17x7.5 et42)
Engine/Drivetrain:
-Steeda STS
-Energy Suspension dogbone inserts
-Marcy Motorsports intake (painted wrinkle black/metalcast red to match the car)
-Resonator replaced with Dynomax Race Bullet
Interior:
-Black flocked (suede) interior trim
-Redline Goods shifter/e-brake boots (black leather with red stitching)
Plans for this winter/ next summer:
-Re-do pinstriping
-Camber arms (hopefully my own soon)
-Build stainless steel 2.5" exhaust
-Figure out an improvement for the Marcy intake (shorten the MAF tube)
-Build a water/debris shield for the intake
-Extend the front fender liners to make clearance for tires
-Tune/ launch control ( <3 FSWerks)
-Get around to the audio install
-Actually do some work on the headlights (paint the new ones matte silver)
-Custom rear springs
-Koni yellows out back.
-PDR on various places (DS rear door!!!)
-Make front lip
-Finish flocked center console, decide on other flocked interior pieces
And the new wheels (among many planned, these are the only ones set in stone):
![]()


















Reply With Quote

